aiwa
New Member
Joined: May 2018
Posts: 8
|
Post by aiwa on Sept 19, 2019 7:28:22 GMT -5
Posted this before but bit of an update and advice! I have built an axial turbine but the last part i need is the stators which i am going to rebuild the front section for but i have a shaft that runs all the way through and wondering the best way to connect it to the motor to spin it up (too much friction in bearings to spin with compressed air) i have tried a temp solution but ends up motor vibrating all over the place and not getting up to its max rpm. youtu.be/0k0X-cqGmzs this is the dry spin with vibrating motors www.youtube.com/watch?v=cQgfgXULb78&list=PL6j4_YB4XCoDdqFz3MSH3LsHh7LeNhyzO this is a playlist of the whole project!
|
|
|
Post by racket on Sept 19, 2019 16:27:06 GMT -5
Hi
Unfortunately there no easy/nice way of saying this ...........................forget trying to start this "engine" , it is doomed to fail , ............mount it on a fancy plinth and sit it aside .
Put your energies into building something that has a chance of working .
Cheers John
|
|