starting to make jet turbine

[jayakod2]

still tring to compleat but difficult to make ngv

[jayakod2]

i cant upload my photos

[Richard OConnell]

If you are uploading as an attachment, make sure the image isnt larger than 1MB, otherwise, you can link to an offsite photo.

[jayakod2]

no its just 14kb why i cant uplode it

[Johansson]

Start an account at Photobucket or a similar site, then you can upload your pics there and link to them from this forum.

[jayakod2]

thanks ill try

[jayakod2]

ohhooo
finaly i uplode pictures of my jet turbine.







i dont have leth machin.i done this with my friend

[jayakod2]

e.com/fileuploads/16906/16906973ad4a86f9af230059d71bdfc77e69e5eb.jpg[/img]

[Johansson]

Hi!

What kind of turbine wheel are you using? Looks like something between an axial and a radial turbine.

The comp wheel sure have seen better days, is it a mockup wheel perhaps? The missing chips at the inducer will mess up rotor balance pretty bad if you try to run the engine with it.

Keep up the good work!

Cheers!
/Anders

[jayakod2]

thanks

as u said comp wheel not well balance one.
but as a trial try to run with it. but i found anothe comp and turbine combination from old terbo chager.
after this trial i try to use this.
Again thanks

[jayakod2]

still there is one problem
shaft of the turbo charger is shorter than may design
so i need to mount long shaft without disturbing the balance of turbine