|
Post by pitciblackscotland on Aug 13, 2012 17:42:20 GMT -5
Pic # 4 Attachments:
|
|
|
Post by pitciblackscotland on Aug 13, 2012 17:41:26 GMT -5
Pic # 3 Attachments:
|
|
|
Post by pitciblackscotland on Aug 13, 2012 17:40:22 GMT -5
Pic # 2 Attachments:
|
|
|
Post by pitciblackscotland on Aug 13, 2012 17:39:21 GMT -5
Hi Anders, Here you go. Cheers, Mark. Attachments:
|
|
|
Post by pitciblackscotland on Aug 13, 2012 3:11:21 GMT -5
Pic # 2 Attachments:
|
|
|
Post by pitciblackscotland on Aug 13, 2012 3:10:24 GMT -5
Hi Anders, I dug out one of my Allison NGVs, thought I'll show this may help you out . Cheers, Mark. Attachments:
|
|
|
Post by pitciblackscotland on Aug 12, 2012 0:51:31 GMT -5
Hi Anders, Very nice machining work from you as always . Cheers, Mark..
|
|
|
Post by pitciblackscotland on Jul 18, 2012 4:59:40 GMT -5
Hi John, Thanks mate, LOL it only took about 8 Months to get it rebuilt. I think next time I'll try someone else Cheers, Mark.
|
|
|
Post by pitciblackscotland on Jul 18, 2012 3:01:53 GMT -5
Welding completed. Attachments:
|
|
|
Post by pitciblackscotland on Jul 18, 2012 2:59:10 GMT -5
Made up a welding jig and made up the top ring and hand beaten the lip with a hammer, i would of like it spun up but i think this will work out OK. Attachments:
|
|
|
Post by pitciblackscotland on Jul 18, 2012 2:53:12 GMT -5
Ready for welding. Attachments:
|
|
|
Post by pitciblackscotland on Jul 18, 2012 2:50:47 GMT -5
Got this tip from John W just wind the silver solder rod around the right dia steel rod and cut the rings out. Attachments:
|
|
|
Post by pitciblackscotland on Jul 18, 2012 2:45:06 GMT -5
Using a 4 jaw chuck and a steel cut off with a 1/2 inch counter sink hole and flaring the tube with a dead center. Attachments:
|
|
|
Post by pitciblackscotland on Jul 18, 2012 2:39:50 GMT -5
I'm using 12 vaporiser tubes at 120mm long and 12.70 DIA. Attachments:
|
|
|
Post by pitciblackscotland on Jul 18, 2012 2:30:25 GMT -5
She's all nice and clean and fully rebuilt, ready to go ;D Attachments:
|
|